Aerosol 1R28

Model No:	1R28

HumiSeal® 1R28 Aerosol is an acrylic conformal coating that provides excellent moisture and environmental protection for printed circuit assemblies. The aerosol can is fitted with an elliptical spray pattern, which provides good control of spray with a well-defined coating edge.

Product Enquiry

HumiSeal® 1R28 Aerosol has the following advantages:

Convenient application by aerosol with no need for dilution
Contains no CFCs or ODPs
Good protection against moisture and dirt
Fluoresces under UV for ease of inspection and is easily repaired.
Good flexibility
Good adhesion to a variety of materials

Application of HumiSeal® 1R28 Aerosol

Allow 48 hours minimum to reach room temperature before using cans stored or received during cold weather.
Mask areas not requiring coating from overspray using suitable non-silicone masking methods or materials.
Shake can vigorously before using and repeat frequently during use.
Best results are obtained by spraying from a distance of 30 - 40cm in light even coats.
Rotate the circuit by 90o between each coat
Recommend 4 coats minimum
A film thickness of 25 - 75 microns is sufficient to provide protection.
To clean nozzle after use, hold can upside down, then press nozzle for a few seconds.
When applied in conditions of high ambient humidity, blushing (cloudy white film) may appear. Heating the coated assembly in an oven for 1/2 hour at 76°C eliminates this condition.

Product Specification
Recommended Coating Thickness	25 - 75 microns
Recommended Curing Conditions	24 hrs @ RT or 30 min @ 76°C
Time Required to Reach Optimum Properties	7 days
Recommended Stripper HumiSeal®	Stripper 1080, 1080EU
Thermal Shock 50 cycles per MIL-I-46058C	-65°C to 125°C
Coefficient of Thermal Expansion - TMA	170 ppm/°C below Tg, 340 ppm/°C above Tg
Glass Transition Temperature - DSC	14°C
Modulus - DMA	2000 MPa @ -40°C
	1050 MPa @ 20°C
	8.5 MPa @ 60°C
Flammability per MIL-I-46058C	Self-Extinguishing
Dielectric Withstand Voltage per MIL-I-46058C	>1500 volts
Dielectric Breakdown Voltage per ASTM D149	7500 volts
Dielectric Constant at 1MHz and 25°C per ASTM D150-98	2.5
Dissipation Factor at 1MHz and 25°C per ASTM D150-98	0.01
Insulation Resistance per MIL-I-46058C	8.0 x 1014 ohms (800TΩ)
Moisture Insulation Resistance per MIL-I-46058C	6.0 x 1010 ohms (60GΩ)
Fungus Resistance per ASTM G21	Passes